Media Articles

Crosby Straightpoint

  This email address is being protected from spambots. You need JavaScript enabled to view it.

 UK: +44(0)2392 484491    USA: +1 918 834 4611

bridge repair with compression load cellsFour Straightpoint (SP) compression load cells were supplied from Lifting Gear Hire’s (LGH) Belgium facility in Antwerp to weigh a bridge that had been removed for repair after a canal boat collision.

The 150t capacity load cells were utilised by marine engineering company Hye NV, which was tasked with fixing the structure that crosses the Brussels-Scheldt sea canal at Humbeek-Sas in Grimbergen, north of the country’s capital city.

The Brussels Times reported that the bridge was struck as it was opening to allow the vessel to pass through. It added that the impact shifted the roadway section of the bascule (moveable) bridge five or six metres out of line on one side, while the mechanism that raises and lowers the two halves of the bridge was also damaged.

Hye, located on the banks of the Scheldt in Antwerp, near Kruibeke, called upon LGH to provide measurements before and after an important phase of the bridge’s restoration. The wireless load cells were positioned under four supporting points of the structure and fed data, capturing individual and collective readings, back to SP’s SW-HHP software on a laptop, where they were read at a safe distance.

The net weight of the bridge was 156.5t but the structure measured 162.5t including a number of components that will be required during re-installation. Davy Kraft, sales engineer at LGH Belgium, explained that there was no necessity to measure centre of gravity but the information was readily available and contained within a detailed report generated by the software and delivered to Hye’s engineers.

He said: “The software is user-friendly and enabled us to give the report to the customer effectively in real time. The system recorded the weight on each individual load cell, total weight, and centre of gravity, and displayed it in a neat HTML report. Together with the hardware, the SP solution added safety and efficiency to a project where timely delivery is important to get the bridge returned to Grimbergen and reopened as soon as possible.”

SP’s compression load cells boast a wireless range of 700m or 2,300 ft. The load cells and software commonly combine to verify the centre of gravity and weight of large and heavy objects that may not be evenly proportioned. Kraft and his team also utilised 100t capacity Hi-Force hydraulic jacks to raise the bridge and lower it onto the load cells.

SP was acquired by lifting and rigging hardware giant The Crosby Group at the turn of the year.

Repair work on the bridge continues.


Please let us know your name.

Invalid Input

Invalid Input

Invalid Input

Please let us know your email address.

Your email does no match please enter again

Invalid Input

Invalid Input

Once you have sent this form it will instantly reach a Crosby SP representative directly, who will respond to your enquiry by email ASAP. Or if you would prefer a call back please let us know in the message.
Note: Gmail email addresses will not be accepted on this form.